Re: [htdig] Configuring ht//dig


Subject: Re: [htdig] Configuring ht//dig
From: J. op den Brouw (MSQL_User@st.hhs.nl)
Date: Wed Sep 13 2000 - 01:22:07 PDT


Are you using 3.1.5? Then you can add --prefix=.... to configure and
edit the CONFIG file to set the options (after you ran configure and
before you run make).

When using 3.2beta series, you can specify most options via
configure

On Tue, 12 Sep 2000, Matthew Wills wrote:

> hello,
> i have installed ht//dig and am now in the process of confiruing it. i tried to run the sample script to create a database but it continues to error out. it says: unable to find configuration file and then shows the absolute location of the config file. this location is incorrect, and was used on a previous installation. what do i have to do to change this? where is it specified? any help would be greatly appreciated. thanks.
>
> matt
>

--jesse
--------------------------------------------------------------------
J. op den Brouw Johanna Westerdijkplein 75
Haagse Hogeschool 2521 EN DEN HAAG
Faculty of Engeneering Netherlands
Electrical Engeneering +31 70 4458936
-------------------- J.E.J.opdenBrouw@st.hhs.nl --------------------

Linux - because reboots are for hardware changes

------------------------------------
To unsubscribe from the htdig mailing list, send a message to
htdig-unsubscribe@htdig.org
You will receive a message to confirm this.
List archives: <http://www.htdig.org/mail/menu.html>
FAQ: <http://www.htdig.org/FAQ.html>



This archive was generated by hypermail 2b28 : Wed Sep 13 2000 - 01:24:17 PDT