Subject: Re: [htdig] Fw: & in Titles
From: Roger Salisbury (email@example.com)
Date: Wed Jun 28 2000 - 08:53:26 PDT
I see that option in 3.1.x, but I do not see any translate_ config options
----- Original Message -----
From: "Reich, Stefan" <Stefan.Reich@dgn-service.de>
To: "Roger Salisbury" <firstname.lastname@example.org>
Sent: Wednesday, June 28, 2000 8:59 AM
Subject: AW: [htdig] Fw: & in Titles
> I'm not quite sure, but I had a similar problem, where a document
> & comes out of htdig with &amp in the source, so it looked like
> in the browser.
> First you should check the HTML source of the result file.
> If this is your problem too, you can switch this behavior off using
> translate_amp: true (check the other translate_ options as well)
> I must confess, I don't understand, why this is switched off by default.
> Maybe this helps
> -----Ursprüngliche Nachricht-----
> Von: Geoff Hutchison [mailto:email@example.com]
> Gesendet: Mittwoch, 28. Juni 2000 15:31
> An: Roger Salisbury
> Cc: firstname.lastname@example.org
> Betreff: Re: [htdig] Fw: & in Titles
> At 12:11 PM -0500 6/26/00, Roger Salisbury wrote:
> >Sorry, running 3.20b2
> > > Is there a way to get the & html code to display the "&" from the
> > > titles??
> I'm not quite sure I understand what you mean. Do you mean that you
> have '&' characters in your titles that are showing up incorrectly in
> The only correct way to show the '&' character in HTML (like the
> htsearch results) is with the & entity. Using the ampersand
> character alone can confuse some browsers.
> -Geoff Hutchison
> Williams Students Online
> To unsubscribe from the htdig mailing list, send a message to
> You will receive a message to confirm this.
To unsubscribe from the htdig mailing list, send a message to
You will receive a message to confirm this.
This archive was generated by hypermail 2b28 : Wed Jun 28 2000 - 06:03:57 PDT